3*CF 120 RGB fans and 1*RGB LED strip pre-installed and synced Included ADD-RGB system controllable by either case button or motherboard, and compatible to other brands’ ADD-RGB products Large mid tower case supporting up to E-ATX(330mm) motherboard 228mm wide tower compartment with 30mm clearance for cable management Supports installation of 120/140/240/280/360/420mm radiator liquid cooling system at front, 120/140/240/280/360mm radiator liquid cooling system at top, 120mm radiator liquid cooling system at rear
The MATREXX 70 3F is a new-concept chassis specially designed for the enjoyment of DIY enthusiasts. By adopting numerous novel structural designs, its architecture yields convenience and flexibility in PC building. Meanwhile three CF 120 RGB fans and one RGB LED strip are included to provide top-notch lighting effects. The MATREXX 70 3F is ready to give you a gaming-ambiance boost.
The ADD-RGB lighting system includes 5 pre-programmed lighting effects (dynamic color, static, breathing, comet and fashioncollision) and can be easily controlled by the RGB button on the I/O panel or motherboard. Meanwhile the special accessory pack enables the syncing between the products from Deepcool and other brands, thereby creating a friendly ADD-RGB ecosystem.
With the bottom hooked to the case structure and the top locked by a spring buckle, the front panel of the MATREXX 70 3F computer case can be set to a “dismounting-ready” state with just one touch. Once the “OPEN” button is pressed, the front panel will be released and held at a 5° angle, ready to be pulled out.
The side panel is fixed with a one-groove + two-screw design. The groove can hold the panel and prevent it from falling, even with no screws mounted, which makes installation much easier. After installation, this unique fixation method will grant the glass panel an even stress-distribution, hence reducing the risk of cracking.
The radiator/fan-holder simplifies installation and replacement of the radiator and fan, making it especially effort-saving when you need to install the radiator and fan on different sides of the holder.
Removable Glass PSU Shroud
With air-intake options at front and bottom, exhaust options at the top and rear, the MATREXX 70 3F provides highly flexible ventilation solutions. Meanwhile the 15mm-wide front-intake hole guarantees sufficient air supply, together with the low-friction material applied on all meshes, maximizing cooling efficiency.
E-ATX (Up to 330mm)
Dust filters are installed at the front, top and bottom of the case. The all-around and fine coverage offers remarkable dust-proof capabilities. Meanwhile, the top filter is magnetic whereas the front/bottom filters are inserted, which makes them very easy to clean.
A total of six 2.5" drives or four 2.5" + two 3.5" drives can be mounted in the MATREXX 70. Two SSD bays are fixed at the back of motherboard tray for quick installation. Two 3.5/2.5" hard-drive bays are mounted at the bottom of the case which are relocatable and removable. After removal, two 120mm fans can be installed at the location.
The front and side panels are made of full-sized, tinted tempered glass. They display your gears with a classy filter while keeping the overall look clean .
The case’s dimensions are 484x233x492mm, offering gigantic room to manage cables (170mm motherboard tray-to-glass clearance, 30mm motherboard tray-to-back plate clearance).
Graphics-card support up to 380mm.
Equipped with large spacing: 170mm (tower room) and 30mm (cable sorting at the rear).
Four 2.5" independent hard-disk slots and two 3.5/2.5" hard-disk spaces.
As the dust screens are installed at the top, bottom and front, it provides remarkable anti-dust capabilities while being easy to clean.